ACR Electronics RCL-75 SEARCHLIGHT Spezifikationen PDF herunterladen (Seite 7)

Y1-03-0158 Rev. D

Depending on the location selected, your light will need 1/4” diameter stainless steel bolts,

nuts, and washers. If mounting area is robust enough panhead lag screws may be used. If the

surface area can be reached from the under side, through bolting with lock nuts and washers

should be used.

5.2 Tools and fasteners needed for installation

4 ea. 1/4” dia. bolts and

4 ea. Lock nuts and

4 ea. Washers or

4 ea. 1/4” dia. Lag screws

1 ea. 1/4" Drill bit for bolt holes or

1 ea. 17/64" Drill bit for lag screws

1 ea. 15/16" Drill bit for cable clearance

1 ea. 13/64" Drill bit for remote switch mounting bolts

1 ea. Tube of silicone or bedding compound to close hole around cable.

Option: 1”mounting riser shapeable for irregular surfaces. (P/N 9427 - Figure 4)

Caution - Be careful when using electrical power tools around water. Electric shock

could occur.

5.3 Mounting the Remote Control Point Pad™

The Point Pad™ should be located within reach of the helm station. Point Pad™ has two

mounting options. Flush mount and Surface mount.(see Figures 6 & 7) Both mounting options

require access to the backside of the mounting location. (see Templates – Y1-03-0158-1) Make

sure there are no obstructions behind the area where the switch is to be located. (i.e. bulkheads,

wires, plumbing, hardware.) Check in advance to verify the wiring harness can be routed to this

location. Use Templates for hole pattern.

5.3.1 Surface Preparation for Remote Control Point Pad™

Make sure area is clean and dry. Mark hole locations for drilling. Verify that drill hole

will not impact or harm other items (wires, plumbing, hardware bulkhead).

5.4 Mounting the Light

Remove deck mounting plate from light base (4 Allen bolts). Save the bolts and washers.

Locate the mounting plate on the spot that you want your light. Rotate the plate so that the

arrows are pointing forward and the length of the arrow is aligned parallel to the keel. Mark

the 4 mounting holes, starting with the one between the 2 arrows. Mounting holes are in 90°

increments. (See template Y1-03-0158-1)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Keine Kommentare

ACR Electronics RCL-75 SEARCHLIGHT Spezifikationen Seite 7